ASAHI KASEI

[AKD4626A-B]

<KM079800>

2005/11

- 8 -

2. Control Software Manual

Set-up of evaluation board and control software

1. Set up the AKD4626A-B according to previous term.

2. Connect IBM-AT compatible PC with AKD4626A-B by 10-line type flat cable (packed with AKD4626A-B). Take

care of the direction of 10pin header. (Please install the driver in the CD-ROM when this control software is used on

Windows 2000/XP. Please refer “Installation Manual of Control Software Driver by AKM device control software”.

In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows

NT.)

3. Insert the CD-ROM labeled “AKD4626A-B Evaluation Kit” into the CD-ROM drive.

4. Access the CD-ROM drive and double-click the icon of “akd4626a.exe” to set up the control program.

5. Then please evaluate according to the follows.

Operation flow

Keep the following flow.

1. Set up the control program according to explanation above.

2. Click “Port Reset” button.

3. Click “Write default” button

Explanation of each buttons

1. [Port Reset] :

Set up the USB interface board (AKDUSBIF-A) when using the board.

2. [Write default] :

Initialize the register of the AK4642EN.

3. [All Write] :

Write all registers that is currently displayed.

4. [Function1] :

Dialog to write data by keyboard operation.

5. [Function2] :

Dialog to write data by keyboard operation.

6. [Function3] :

The sequence of register setting can be set and executed.

7. [Function4] :

The sequence that is created on [Function3] can be assigned to buttons and executed.

8. [Function5]:

The register setting that is created by [SAVE] function on main window can be assigned to

buttons and executed.

9. [SAVE] :

Save the current register setting.

10. [OPEN] :

Write the saved values to all register.

11. [Write] :

Dialog to write data by mouse operation.

Indication of data

Input data is indicated on the register map. Red letter indicates “H” or “1” and blue one indicates “L” or “0”. Blank is the

part that is not defined in the datasheet.