H8SXSLASH1663 datasheet(562/1158 Pages) RENESAS

562 / 1158 page

Section 10 16-Bit Timer Pulse Unit (TPU)

Rev.1.00 Jun. 07, 2006 Page 510 of 1102

REJ09B0294-0100

Table 10.12 MD3 to MD0

Bit 3

MD3*

Bit 2

MD2*

Bit 1

MD1

Bit 0

MD0

Description

Normal operation

Reserved

PWM mode 1

PWM mode 2

Phase counting mode 1

Phase counting mode 2

Phase counting mode 3

Phase counting mode 4



[Legend]

X: Don't care

Notes: 1. MD3 is a reserved bit. The write value should always be 0.

2. Phase counting mode cannot be set for channels 0 and 3. In this case, 0 should always

be written to MD2.

10.3.3

Timer I/O Control Register (TIOR)

TIOR controls TGR. The TPU has eight TIOR registers, two each for channels 0 and 3, and one

each for channels 1, 2, 4, and 5. Care is required since TIOR is affected by the TMDR setting.

The initial output specified by TIOR is valid when the counter is stopped (the CST bit in TSTR is

cleared to 0). Note also that, in PWM mode 2, the output at the point at which the counter is

cleared to 0 is specified.

When TGRC or TGRD is designated for buffer operation, this setting is invalid and the register

operates as a buffer register.

To designate the input capture pin in TIOR, the DDR bit and ICR bit for the corresponding pin

should be set to 0 and 1, respectively. For details, see section 9, I/O Ports.

H8SX/1663 数据表(PDF) 562 Page - Renesas Technology Corp

H8SX/1663 数据表(HTML) 562 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载