ATmega169P datasheet(242/393 Pages) ATMEL

242 / 393 page

242

8018N–AVR–08/09

ATmega169P

Note:

1. See ”About Code Examples” on page 10.

Before a re-initialization is done, the LCD controller/driver should be disabled

23.4.2

Updating the LCD

Display memory (LCDDR0, LCDDR1, ..), LCD Blanking (LCDBL), Low power waveform

(LCDAB) and contrast control (LCDCCR) are latched prior to every new frame. There are no

restrictions on writing these LCD Register locations, but an LCD data update may be split

between two frames if data are latched while an update is in progress. To avoid this, an interrupt

routine can be used to update Display memory, LCD Blanking, Low power waveform, and con-

trast control, just after data are latched.

Assembly Code Example

(1)

LCD_Init:

; Use 32 kHz crystal oscillator

; 1/3 Bias and 1/3 duty, SEG21:SEG24 is used as port pins

ldi

r16, (1<<LCDCS) | (1<<LCDMUX1)| (1<<LCDPM2)

sts

LCDCRB, r16

; Using 16 as prescaler selection and 7 as LCD Clock Divide

; gives a frame rate of 49 Hz

ldi

r16, (1<<LCDCD2) | (1<<LCDCD1)

sts

LCDFRR, r16

; Set segment drive time to 125

µs and output voltage to 3.3 V

ldi

r16, (1<<LCDDC1) | (1<<LCDCC3) | (1<<LCDCC2) | (1<<LCDCC1)

sts

LCDCCR, r16

; Enable LCD, default waveform and no interrupt enabled

ldi

r16, (1<<LCDEN)

sts

LCDCRA, r16

ret

C Code Example(1)

Void LCD_Init(void);

{

/* Use 32 kHz crystal oscillator */

/* 1/3 Bias and 1/3 duty, SEG21:SEG24 is used as port pins */

LCDCRB = (1<<LCDCS) | (1<<LCDMUX1)| (1<<LCDPM2);

/* Using 16 as prescaler selection and 7 as LCD Clock Divide */

/* gives a frame rate of 49 Hz */

LCDFRR = (1<<LCDCD2) | (1<<LCDCD1);

/* Set segment drive time to 125

µs and output voltage to 3.3 V*/

LCDCCR = (1<<LCDDC1) | (1<<LCDCC3) | (1<<LCDCC2) | (1<<LCDCC1);

/* Enable LCD, default waveform and no interrupt enabled */

LCDCRA = (1<<LCDEN);

}

ATmega169P 数据表(PDF) 242 Page - ATMEL Corporation

ATmega169P 数据表(HTML) 242 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载