ADE06 datasheet(293/326 Pages) MACOM

293 / 326 page

Index/Matrixes

Catalog 1308390

Dimensions are in inches

Dimensions are shown for

USA: 1-800-522-6752

South America: 55-11-3611-1514

Issued 9-04

and millimeters unless otherwise

reference purposes only.

Canada: 1-905-470-4425

Hong Kong: 852-2735-1628

specified. Values in parentheses

Specifications subject

Mexico: 01-800-733-8926

Japan: 81-44-844-8013

www.tycoelectronics.com

or brackets are metric equivalents. to change.

C. America: 52-55-5-729-0425

UK: 44-141-810-8967

Catalog 1308390

Dimensions are in inches

Dimensions are shown for

USA: 1-800-522-6752

South America: 55-11-3611-1514

Issued 9-04

and millimeters unless otherwise

reference purposes only.

Canada: 1-905-470-4425

Hong Kong: 852-2735-1628

specified. Values in parentheses

Specifications subject

Mexico: 01-800-733-8926

Japan: 81-44-844-8013

www.tycoelectronics.com

or brackets are metric equivalents. to change.

C. America: 52-55-5-729-0425

UK: 44-141-810-8967

Glossary

• End of Life Criteria: Those specifications that a switch must

meet at the end of its specified electrical life. Typically contact

resistance and/or heat rise of contacts at full rated load at end of

life.

• Environmental Seal: A seal that totally encapsulates the switch

or relay providing a specified level of protection against

intrusion of solids, liquids or gases into the body of the device.

• Fixed Contact (Stationary or Statis Contact): The non-moving

contact. Typically integral to the end of the terminal inside the

switch body.

• Flux: A material added during soldering to the metal surfaces

which on heating prevents oxidation and aids the flowing of the

solder.

• Gas-Tight Contact: A contact interface (movable to fixed

contacts) in which the forces holding the contacts together are

high enough to prevent gases from migrating between the

members. This prevents static oxidation of the contact and

subsequent intermittencies of high contact resistance. Typical

forces are 280,000 PSI and higher.

• Gold Flash: A plating of gold typically less than 10 microinches

(millionths) thick. Used only as a barrier to oxidation or

corrosion of terminals to maintain solderability.

• Heat Rise: An indirect measurement of contact resistance used

by rating agencies. The temperature rise over ambient of a

contact set carrying a prescribed current is measured to

determine whether it falls within safe limits.

• Inductive Load: A load in which the initial current on making

(closing) of the contacts is lower than the steady state. On

breaking (opening) of the contacts, the current is greater than

the steady state. Current lags voltage in inductive loads. Motors

are the most common inductive load. See Resistive Load,

Capacitive Load, Power Factor.

• Inrush: A transitory high-level of current through a contact set

on making (closing). A characteristic of capacitive and some

resistive loads. The inrush currents can be large and long

enough to cause severe degredation of the contacts. See

Resistive Load, Capacitive Load, Power Factor.

• Insert Molding: In switches and relays used to refer to

terminations that are placed in the mold so that plastic is

molded around the terminations. The chief benefit is an

inherent seal against the intrusion of flux into the body of the

device. Therefore no epoxy terminal seal is required.

• Insulation Resistance: The resistance between insulated parts

measured at a specified DC voltage. Unit of Measure:

Megohm.

• IP: An industrial specification used in Europe (and worldwide) to

indicate the degree of protection provided by a component

against accidental contact, penetration of solids or liquids into

or through the component. See NEMA.

• Leakage Barrier: A ridge or web molded into a switch housing

between terminals or contacts to increase the surface distance

between them.

• Leakage Resistance: Dielectric Strength.

• Life: See Electrical Life: Mechanical Life.

• Logic Level: Refers to power levels typical of solid state

electronic circuits (TTL, CMOS, etc.). For switch selection see

Dry Circuit.

• Low Energy: See Dry Circuit.

• Maintained: A position (throw) of a switch which remains

unchanged when actuation force is removed from switch

actuator. Contrast with Momentary.

• Make-Before-Break (Shorting Contact, Make First): Movable

contact makes the next circuit before breaking the first circuit.

Typically found in slide switches. Contrast with Break-Before-

Make (MBB).

• Make First: See Make-Before-Break.

• Mechanical Life: The number of operations of a switch without

electrical load that does not result in a degredation of

parameters beyond the standard set by the applicable end-of-

life criteria.

• Momentary (Spring Return): A momentary switch position

(throw) is held only for duration of force applied to the switch

actuator.

• Movable Contact (Dynamic Contact): The contact moved by

the switch actuator into and away from contact with a fixed

contact thus forming the electrical circuits possible for a given

device.

• N.C.: See Normally Closed.

• NEMA: National Electrical Manufacturers Association. A US

Standards setting group for switch products most often applied

to switches mounted in various enclosures offering specified

degrees of protection against intrusion of liquids, dust,

corrosive elements, etc. NEMA ratings are common in

industrial or outdoor applications. See IP.

• NO: See Normally Open.

• Non-shorting: See Break-Before-Make.

• Non-switching Rating: The power carrying capacity of a switch

after contact closure and end of contact bounce. Typically far

higher than the contact rating (switching rating) of a switch.

Unit of Measure: Volts and Amps.

• Normally Closed (NC): Normally closed contacts are closed

when switch actuator is in its unactuated position (e.g., the

plunger is in the resting position in the case of a pushbutton

switch).

• Normally Open (NO): Normally open contacts are open when

the switch actuator is in its unactuated or resting position.

ADE06 数据表(PDF) 293 Page - Tyco Electronics

ADE06 数据表(HTML) 293 Page - Tyco Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载