MPXV2202DP datasheet(508/670 Pages) MOTOROLA

508 / 670 page

AN1571

3–362

Motorola Sensor Device Data

www.motorola.com/semiconductors

SELECTION OF MICROCONTROLLER

Although the microcontroller used in this project is

MC68HC05B16, a smaller ROM version microcontroller can

also be used. The table below shows the requirement of

microcontroller for this blood pressure meter design in this

project.

Table 1. Selection of microcontroller

On–chip ROM space 2 kilobytes

On–chip RAM space 150 bytes

2–channel A/D converter (min.)

16–bit free running counter timer

LCD driver

On–chip EEPROM space 32 bytes

Power saving Stop and Wait modes

CONCLUSION

This circuit design concept may be used to evaluate

Motorola pressure sensors used in the digital blood pressure

meter. This basic circuit may be easily modified to provide

suitable output signal level. The software may also be easily

modified to provide better analysis of the SBP and DBP of a

person.

REFERENCES

Lucas, Bill (1991). “An Evaluation System for Direct Interface

of the MPX5100 Pressure Sensor with a Microprocessor,”

Motorola Application Note AN1305.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MPXV2202DP 数据表(PDF) 508 Page - Motorola, Inc