The part number **40887** typically refers to a specific type of **Electronic Connector** or a **Nylon Cable Tie**, depending on the manufacturer (most commonly associated with **Molex** or **TE Connectivity**). In the context of electronics, the most frequent association for this part number is with **Molex KK series** or **Tyco/TE Connectivity** terminals. --- ### 1. General Specifications If referring to a standard electronic terminal (like the Molex 40887 series), here are the typical technical characteristics: | Property | Description | | :--- | :--- | | **Component Type** | Crimp Terminal / Connector | | **Material** | Phosphor Bronze or Brass | | **Plating** | Tin or Gold (depending on sub-variant) | | **Wire Gauge (AWG)** | Typically 22-30 AWG | | **Voltage Rating** | Up to 250V | | **Current Rating** | ~2.5A to 4.0A (depending on pitch) | --- ### 2. Common Manufacturers While many companies use numerical internal codes, the following are the primary "40887" components found in electronic supply chains: #### A. Molex (40887 Series) * **Application:** These are often female crimp terminals used in 2.54mm (0.100") pitch housings. * **Usage:** Internal computer wiring, sensors, and PCB-to-wire connections. #### B. TE Connectivity / AMP * **Application:** Often refers to specific lugs or ring terminals used for grounding and power distribution. * **Feature:** High conductivity and corrosion resistance. #### C. Industrial Hardware (Nylon Ties) * In some catalogs, 40887 refers to **UV-resistant Cable Ties** used for wire management and cable bundling in electronic enclosures. --- ### 3. Usage & Installation To properly use electronic parts in this category, specific tools and steps are required: 1. **Stripping:** Remove the insulation from the wire (usually 2.5mm to 3.0mm). 2. **Crimping:** Use a dedicated crimping tool (e.g., Molex Hand Crimp Tool) to secure the 40887 terminal to the wire. 3. **Insertion:** Push the terminal into the plastic connector housing until it "clicks" into place. 4. **Testing:** Perform a "tug test" to ensure the mechanical connection is solid. --- ### Summary Checklist for Selection When ordering a 40887 part, verify the following to ensure compatibility: * **Pitch:** Is it 2.54mm or a different spacing? * **Plating:** Do you need Tin (standard) or Gold (low signal/high reliability)? * **Quantity:** Are they sold as individual loose pieces or on a continuous reel?