M95320-RMB3TGSLASHP
AI

The **M95320-RMB3TG/S** is a specific variant of a serial SPI (Serial Peripheral Interface) EEPROM (Electrically Erasable Programmable Read-Only Memory) manufactured by STMicroelectronics.
---
### 1. Key Technical Specifications
Below are the primary technical parameters for this electronic component:
| Feature | Specification |
| :--- | :--- |
| **Memory Size** | 32 Kbit (4,096 bytes) |
| **Interface** | SPI (Serial Peripheral Interface) |
| **Clock Frequency** | Up to 20 MHz (depending on voltage) |
| **Operating Voltage** | 1.8V to 5.5V |
| **Operating Temperature** | -40°C to +125°C (Automotive Grade) |
| **Package Type** | UFDFPN8 (Ultra-thin Fine-pitch Dual Flat No-lead) |
| **Write Cycles** | 4 million cycles (typical) |
| **Data Retention** | 200 years |
---
### 2. Pinout Configuration
The M95320 series typically uses an 8-pin layout. In the **UFDFPN8** package, the configuration is as follows:
1. **S# (Chip Select):** Activates the device for communication.
2. **Q (Serial Data Output):** Data shifts out on the falling edge of the clock.
3. **W# (Write Protect):** Hardware protection to prevent writing to the memory.
4. **VSS:** Ground.
5. **D (Serial Data Input):** Data shifts in on the rising edge of the clock.
6. **C (Serial Clock):** Provides the timing for data transfer.
7. **HOLD#:** Pauses serial communication without resetting the chip.
8. **VCC:** Supply voltage.
---
### 3. Functional Breakdown
* **SPI Protocol:** It supports Mode 0 (0,0) and Mode 3 (1,1). It is designed to work at high speeds compared to I2C-based EEPROMs.
* **Block Protection:** The device includes a Status Register that allows the user to software-protect quarter, half, or the entire memory array.
* **Page Write:** It allows writing up to 32 bytes in a single instruction cycle, which significantly improves write throughput.
* **Automotive Grade (/S Suffix):** The "/S" in the part number usually indicates a specific high-reliability or automotive-grade screening process, making it suitable for harsh environments like engine control units or sensory modules.
---
### 4. Part Number Breakdown
* **M95:** SPI Family.
* **320:** 32 Kbit density.
* **R:** 1.8V to 5.5V range.
* **MB:** UFDFPN8 (2x3 mm) package.
* **3:** Range 3 temperature (-40 to +125 °C).
* **TG:** Tape and Reel packing.
* **/S:** Specific automotive or high-reliability process flow.
- ⤷What are the main differences between SPI and I2C EEPROMs?
- ⤷ How does the Write Protect (W#) pin interact with the status register?
- ⤷ What are the common use cases for 32Kbit EEPROMs in automotive electronics?