数据搜索系统,热门电子元器件搜索
  Chinese  ▼
ALLDATASHEETCN.COM

X  

  • SAS-R

  • AI
    The term **SAS-R** typically refers to components associated with **Serial Attached SCSI (SAS)** systems, specifically the **Receptacles** (connectors) and the **Redrivers/Retimers** used to maintain signal integrity over high-speed PCB traces. --- ## 1. Core Electronic Components of SAS SAS is a high-speed point-to-point protocol used for data transfer between storage devices (HDDs/SSDs) and controllers. ### A. SAS Receptacles (The "R" in SAS-R) The physical interface (connector) on the backplane or the drive. * **Dual-Porting:** Unlike SATA, SAS connectors have a second port on the back to provide a redundant path to the data. * **Form Factors:** Common types include **SFF-8482** (internal drive side) and **SFF-8639** (NVMe/SAS hybrid). ### B. Signal Conditioning: Redrivers and Retimers Because SAS operates at high frequencies (up to 12Gbps or 22.5Gbps), the electrical signal degrades over copper traces. * **Redriver:** An analog amplifier that boosts the signal and performs equalization to compensate for transmission loss. * **Retimer:** A more complex digital component that recovers the clock and re-transmits a clean version of the signal. --- ## 2. Technical Specifications Table | Feature | SAS 3.0 (Typical) | SAS 4.0 (Latest) | | :--- | :--- | :--- | | **Data Rate** | 12 Gbps | 22.5 Gbps | | **Encoding** | 8b/10b | 128b/130b | | **Voltage Swing** | 800 - 1200 mV | 800 - 1200 mV | | **Connector Type** | SFF-8643 / SFF-8644 | SFF-8611 (Oculink) / SlimSAS | --- ## 3. PCB Layout Considerations When designing electronics for SAS-R interfaces, engineers must focus on **Signal Integrity (SI)**: 1. **Differential Pairs:** SAS uses differential signaling. Traces must be length-matched to within very tight tolerances (usually < 5 mils) to prevent phase skew. 2. **Impedance Control:** The characteristic impedance must be strictly maintained at **100 Ohms** (differential). 3. **AC Coupling Capacitors:** To isolate DC voltages between the transmitter and receiver, 0.01µF to 0.1µF capacitors are placed in series on the high-speed lines. ### Example: Typical SAS Interface Circuit ```c [Controller IC] ----> [AC Caps] ----> [Redriver Chip] ----> [SAS Receptacle] ``` ---
    ✨ Follow-up Questions
    • ⤷ What is the difference between a SAS Redriver and a Retimer in terms of latency?
    • ⤷ How does the SFF-8482 connector differ electrically from a standard SATA connector?
    • ⤷ What are the common power rail requirements for SAS backplane electronics?