Description
The 601-CS-D-P1 3-phase power monitor is a fully programmable
electronic power monitor designed to monitor 3-phase systems.
The 601-CS-D-P1 has a single relay that can be configured as
a general purpose network output or to trip on ground faults.
The 601-CS-D-P1 monitors ground fault current, phase currents,
phase voltages, power factor and frequency. The RS485MS-2W
communications module allows the 601-CS-D-P1 to communicate
using the Modbus RTU protocol. The Modbus connection can be
used to monitor power parameters, setup the device or control
the fault relay. A DeviceNet™ communications I/O module
(CIO-601CS-DN-P1) is available as well. This CIO module only
works with the 601-CS-D-P1 unit. It is used for sending the
information from the 601-CS-D-P1 over a DeviceNet™ network.
It also provides I/O capabilities and the ability to set the
parameters of the 601-CS-D-P1.
Note: This product must be used with an external Zero-Sequence CT for proper operation
(not included).

FEATURES BENEFITS
Built-in display
Visual indication for programming and viewing
real-time parameters for nominal voltage, voltage
unbalance, current, current unbalance, ground
fault warning, ground fault trip, and ground fault
motor acceleration
15 Programmable
parameters to control
the device operation
Allows the user to customize the protection required
for their system
2 programmable trip
delay timers
Program separate trip delay time for motor
acceleration and ground fault
Network
communications
capability
Compatible with Modbus RTU and DeviceNet™
protocols with the use of separate
communications module