Features
• AEC-Q100 qualified
• Pre SMPS BUCK regulator, adjustable via OTP to 1.0 V, 1.1 V, 1.2 V, 1.35 V,
1.5 V, 3.3 V, 3.6 V, 5.0 V at 1.35/2.6 A min peak current limit, 0.4/2.4 MHz
• Post SMPS BOOST regulator, adjustable via OTP to 5.0 V at 0.3 A max load
current, 7.0 V at 0.2 A max load current, 2.4 MHz
• Post Linear regulator LDO, adjustable via OTP to 1.2 V, 1.25 V, 1.3 V, 1.8 V,
2.5 V, 2.8 V, 3.3 V, 5.0 V at 300/600 mA max load current
• Precise Voltage reference, adjustable via OTP to 1.8 V, 2.5 V, 3.3 V,
4.1 V at 20 mA max load current
• SPI interface with CRC
• Programmable slew rate/soft start
• Voltage supervisors
• Spread frequency spectrum
• Reset and reset sensitivity list
• Adjustable window watchdog supervisors
• Programmed power up phase via OTP
• Short circuit protected outputs and Fault detection pin to Microcontroller
• Low external components number
• Thermal shutdown junction temperature 175 °C

Description
STPM066S is a multiple voltage regulator composed by one battery compatible
BUCK pre-regulator, one BOOST, one LDO and a precise voltage reference
regulator. All the regulators have internal power switches.
OTP (One Time Programmable) cells are used for the main device parameters
programming (output voltages and currents, switching frequencies) and to configure
the power up sequence.
An SPI interface can be used to enable or disable the single voltage regulators, for
diagnostic information and to program internal blocks parameters (monitor and Power
Good thresholds, slew rate, etc.).
The device offers a set of features to support applications that need to fulfill functional
safety requirements as defined by Automotive Safety Integrity Level (ASIL) A-B-C-D.