Features List
◆ RC32300 32-bit Microprocessor
– Enhanced MIPS-II ISA
– Enhanced MIPS-IV cache prefetch instruction
– DSP Instructions
– MMU with 16-entry TLB
– 8KB Instruction Cache, 2-way set associative
– 2KB Data Cache, 2-way set associative
– Per line cache locking
– Write-through and write-back cache management
– Debug interface through the EJTAG port
– Big or Little endian support
◆ Interrupt Controller
– Allows status of each interrupt to be read and masked
◆ I2C
– Flexible I2C standard serial interface to connect to a variety of
peripherals
– Standard and fast mode timing support
– Configurable 7 or 10-bit addressable slave
◆ UARTs
– Two 16550 Compatible UARTs
– Baud rate support up to 1.5 Mb/s
◆ Counter/Timers
– Three general purpose 32-bit counter/timers
◆ General Purpose I/O Pins (GPIOP)
– 36 individually programmable pins
– Each pin programmable as input, output, or alternate function
– Input can be an interrupt or NMI source
– Input can also be active high or active low
◆ SDRAM Controller
– 2 memory banks, non-interleaved, 512 MB total
– 32-bit wide data path
– Supports 4-bit, 8-bit, and 16-bit wide SDRAM chips
– SODIMM support
– Stays on page between transfers
– Automatic refresh generation
◆ Peripheral Device Controller
– 26-bit address bus
– 32-bit data bus with variable width support of 8-,16-, or 32-bits
– 8-bit boot ROM support
– 6 banks available, up to 64MB per bank
– Supports Flash ROM, PROM, SRAM, dual-port memory, and
peripheral devices
– Supports external wait-state generation, Intel or Motorola style
– Write protect capability
– Direct control of optional external data transceivers
◆ System Integrity
– Programmable system watchdog timer resets system on timeout
– Programmable bus transaction times memory and peripheral
transactions and generates a warm reset on time-out
◆ DMA
– 16 DMA channels
– Services on-chip and external peripherals
– Supports memory-to-memory, memory-to-I/O, and I/O-to-I/O
transfers
– Supports flexible descriptor based operation and chaining via
linked lists of records (scatter / gather capability)
– Supports unaligned transfers
– Supports burst transfers