DESCRIPTION
The MPQ6610 is a half-bridge driver with
current measurement and regulation features. It
can operate from a 4V to 55V supply voltage,
and can deliver up to 3A of output current
(depending on the package, PCB design, and
ambient temperature). The MPQ6610 can be
used to drive brushed DC motors, solenoids, or
other loads.
An internal current-sense circuit provides an
output with a voltage that is proportional to the
load current. Cycle-by-cycle current regulation
and limiting are also provided. These features
do not require the use of a low-Ohmic shunt
resistor.
Internal diagnostic and protection features
include open-load detection, over-current
protection (OCP), under-voltage lockout
(UVLO), and thermal shutdown.
The MPQ6610 is available in 8-pin TSOT23
and SOIC-8 packages. Note that due to the
small pin spacing, the TSOT23 package is only
recommended for applications up to 45V,
unless conformal coating or encapsulation is
used.

FEATURES
 Wide 4V to 55V Input Voltage Range
 3A Maximum Output Current
 Internal Half-Bridge Driver
 Cycle-by-Cycle Current Regulation/Limiting
 Low On Resistance (High Side: 100mΩ,
Low Side: 120mΩ)
 No Control Power Supply Required
 Simple, Versatile Logic Interfaces
 Inputs Compatible with 2.5V, 3.3V, and 5V
Logic
 Over-Current Protection (OCP)
 Open-Load Detection
 Thermal Shutdown
 Under-Voltage Lockout (UVLO)
 Fault Indication Output
 Thermally Enhanced Package
 Available in TSOT23 and SOIC-8 Packages
 Available in AEC-Q100 Grade 1

APPLICATIONS
 Solenoid Drivers
 Relay Drivers
 Brushed DC Motor Drivers