■ GENERAL DESCRIPTION
The MBM29F040C is a 4M-bit, 5.0 V-only Flash memory organized as 512K bytes of 8 bits each. The MBM29F040C is offered in a 32-pin PLCC and 32-pin TSOP(I) package. This device is designed to be programmed in-system with the standard system 5.0 V VCC supply. A 12.0 V VPP is not required for write or erase operations. The device can also be reprogrammed in standard EPROM programmers.

■ FEATURES
• Single 5.0 V read, program and erase
    Minimizes system level power requirements
• Compatible with JEDEC-standard commands
    Uses same software commands as E2PROMs
• Compatible with JEDEC-standard byte-wide pinouts
    32-pin PLCC (Package suffix: PD)
    32-pin TSOP(I) (Package suffix: PF)
    32-pin TSOP(I) (Package suffix: PFTN – Normal Bend Type, PFTR – Reversed Bend Type)
• Minimum 100,000 write/erase cycles
• High performance
    55 ns maximum access time
• Sector erase architecture
    8 equal size sectors of 64K bytes each
    Any combination of sectors can be concurrently erased. Also supports full chip erase.
• Embedded Erase™ Algorithms
    Automatically pre-programs and erases the chip or any sector
• Embedded Program™ Algorithms
    Automatically writes and verifies data at specified address
• Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Low VCC write inhibit ≤ 3.2 V
• Sector protection
    Hardware method disables any combination of sectors from write or erase operations
• Erase Suspend/Resume
    Suspends the erase operation to allow a read data in another sector within the same device