Features
■Rectangular, plastic, Ultem
■Status displayed via LED
■Angle detection via one axis with 360 °
measuring range
■High protection class IP68/IP69K
■Protected against salt spray and rapid
temperature change
■15…30 VDC
■M12 × 1 male connector, 5-pin
■Two counter-running 4…20 mA analog
outputs improve machine safety through
redundancy
■The start, end and center point of the
measuring range can be adjusted using teach
adaptor TX1-Q20L60
■Individual parameterization possible with
USB-2-IOL-0002

Functional principle
The inclinometers use an acceleration
measuring cell to determine the angle. The
Earth's gravity is used as a reference. If the
inclinometer changes its angle relative to
the Earth's gravity, this is detected by the
acceleration measuring cell.
The robust sensors are positioned with the
cast side on a flat surface so that the casting
compound is covered. The sensor is then
secured with two screws.