Features
■Tag for direct mounting on metal
■The mounting position (arrow) as well
as the alignment of the tag towards the
read/write head must be observed under
all circumstances in order to achieve a
maximum read/write distance
■When installed recessed in metal by 1 mm,
the write/read distance reduces to 30%
■Extended storage temperature range: The
tags must undergo adequate stress tests
within the proposed temperature processes
before deployment.
■The following stress test was performed on
this tag:
Cyclic temperature stress: 5 min. at 20 °C –
5 min. at 160 °C.
Number of tested cycles: 100T
This successfully performed test does
not imply suitability for a specific hightemperature application, but merely serves
as proof of the basic usability.
■EEPROM, memory 146 byte
■For direct mounting on metal

Functional principle
The HF read/write devices operating at a
frequency of 13.56 MHz form a transmission
zone the size of which (0…500 mm) varies,
depending on the combination of read/write
head and tag used.
The read/write distances mentioned here only
represent standard values measured under
laboratory conditions, free from any influences
caused by surrounding materials.
The read/write distances of tags suitable for
mounting in/on metal were determined in/on
metal.
Attainable distances may vary by up to 30
% due to component tolerances, mounting
conditions, ambient conditions and material
qualities (especially when mounted in metal).
Testing of the application under real operating
conditions is therefore essential, especially
with on-the-fly reading and writing!