Additional Application Notes
1: It is possible that during transit or final assmely the relay could change state. Therefore, it is recommended that all relays be set to
the desired state via a power supply.
2: In order to maintain an "Open" or "Closed" state of the relay, the coil voltage should reach the rated voltage. The pulse width should
be 50ms minimum to ensure a proper change of state. DO NOT energize both T1 and T2 at the same time on a Dual Coil or energize
the coil longer than 1 minute (damage to the coil could occur).
3: For assistance with wave solder process settings, please contact KG Technologies.
4: For defineitions of terms used in this data sheet, see glossary at: https://kgtechnologies.net/pages/data-sheet-glossary