|
Features ■ Suitable for use in digital tuning systems in high-fi tuners and car stereos. ■ Built-in prescalers operate at an input frequency ranging from 30 to 150 MHz during FMIN input (with two-modulus prescaler) and at 0.5 to 40 MHz during AMIN input (with ■ two-modulus prescaler or direct dividing) ■ 16-bit programmable counter, dual parallel output phase comparator, crystal oscillator and reference counter ■ 3.6 MHz, 4.5 MHz, 7.2 MHz or 10.8 MHz crystal oscillators can be used. ■ 15 possible reference frequencies (when using 4.5 MHz crystal):ref. = 0.5 k, 1 k, 2.5 k, 3 k, 3.125 k, 3.90625 k, 5 k, 6.25 k, 7.8125 k, 9 k, 10 k, 12.5 k, 25 k, 50 k and 100 kHz. ■ Built-in 20-bit general-purpose counter for such uses as measuring intermediate frequencies (IFIN1 and IFIN2) and low-frequency pilot signal cycles (SCIN). (No cycle measurement function is available on the TC9256APG and ■ TC9256AFG.) ■ High-precision (±0.55 to ±7.15 µs) PLL phase error detection ■ Numerous general-purpose I/O pins for such uses as ■ peripheral circuit control ■ Four N-channel open-drain output ports (OFF withstanding voltage: 12 V) for such uses as control signal output. (TC9256APG and TC9256AFG have only three ports.) ■ Standby mode function (turns off FM, AM and IF amps) to ■ save current consumption ■ All functions controlled through three serial bus lines ■ CMOS structure with operating power supply range of VDD = 5.0 ± 0.5 V. ■ 16-pin DIP (TC9256APG), 20-pin DIP (TC9257APG), 16-pin SOP (TC9256AFG), 20-pin SOP (TC9257AFG) packages TC9256APG TC9257APG TC9256AFG TC9257AFG Weight P-DIP16-300-2.54A: 1.0 g (typ.) P-DIP20-300-2.54A: 1.24 g (typ.) P-SOP16-300-1.27A: 0.16 g (typ.) P-SOP20-300-1.27A: 0.48 g (typ.)
|