1FEATURES
2• No Special Start-up Sequence Required
between Clock/Data and /PD Pins. Input Signal
(Clock and Data) can be Applied Either Before
or After the Device is Powered.
• Support Spread Spectrum Clocking up to
100KHz Frequency Modulation & Deviations of
±2.5% Center Spread or −5% Down Spread.
• "Input Clock Detection" Feature will Pull all
LVDS Pairs to Logic Low when Input Clock is
Missing and when /PD Pin is Logic High.
• 18 to 68 MHz Shift Clock Support
• Best–in–Class Set & Hold Times on TxINPUTs
• Tx Power Consumption < 130 mW (typ)
@65MHz Grayscale
• 40% Less Power Dissipation than BiCMOS
Alternatives
• Tx Power-Down Mode < 37μW (typ)
• Supports VGA, SVGA, XGA and Dual Pixel
SXGA.
• Narrow Bus Reduces Cable Size and Cost
• Up to 1.3 Gbps Throughput
• Up to 170 Megabytes/sec Bandwidth
• 345 mV (typ) Swing LVDS Devices for Low EMI
• PLL Requires no External Components
• Compatible with TIA/EIA-644 LVDS Standard
• Low Profile 48-lead TSSOP Package
• Improved Replacement for:
– SN75LVDS84, DS90CF363A

DESCRIPTION
The DS90CF363B transmitter converts 21 bits of
CMOS/TTL data into three LVDS (Low Voltage
Differential Signaling) data streams. A phase-locked
transmit clock is transmitted in parallel with the data
streams over a fourth LVDS link. Every cycle of the
transmit clock 21 bits of input data are sampled and
transmitted. At a transmit clock frequency of 65 MHz,
18 bits of RGB data and 3 bits of LCD timing and
control data (FPLINE, FPFRAME, DRDY) are
transmitted at a rate of 455 Mbps per LVDS data
channel. Using a 65 MHz clock, the data throughput is 170 Mbytes/sec. The DS90CF363B is fixed as a
Falling edge strobe transmitter and will interoperate
with a Falling edge strobe Receiver (DS90CF366)
without any translation logic.
This chipset is an ideal means to solve EMI and
cable size problems associated with wide, high speed
TTL interfaces.