1 Features
1• At VS = 5V, typical unless noted.
• Greater than Rail-to-rail Input CMVR −0.2 5V to
5.25 V
• Rail-to-rail Output Swing 0.01 V to 4.99 V
• Wide Gain-bandwidth 75 MHz @ 100 kHz
• Slew Rate
– Small Signal 5 V/μs
– Large Signal 45 V/μs
• Low Supply Current 1.4 mA/amplifier
• Wide Supply Range 2.7 V to 24 V
• Fast Settling Time of 1.1 μs for 2 V Step (to
0.01%)
• PSRR 91 dB
• CMRR 84 dB

2 Applications
• Portable High Speed Instrumentation
• Signal Conditioning Amplifier/ADC Buffers
• Barcode Scanners

3 Description
Using patented circuit topologies, the
LM6152/LM6154 provides new levels of speed vs. power performance in applications where low voltage
supplies or power limitations previously made
compromise necessary. With only 1.4 mA/amplifier
supply current, the 75 MHz gain bandwidth of this
device supports new portable applications where higher power devices unacceptably drain battery life.
The slew rate of the devices increases with
increasing input differential voltage, thus allowing the
device to handle capacitive loads while maintaining large signal amplitude.
The LM6152/LM6154 can be driven by voltages that
exceed both power supply rails, thus eliminating concerns about exceeding the common-mode voltage
range. The rail-to-rail output swing capability provides
the maximum possible dynamic range at the output.
This is particularly important when operating on low
supply voltages.
Operating on supplies from 2.7 V to over 24 V, the
LM6152/LM6154 is excellent for a very wide range of applications, from battery operated systems with
large bandwidth requirements to high speed
instrumentation.