1FEATURES
2• Controlled Baseline
– One Assembly/Test Site, One Fabrication
Site
• Enhanced Diminishing Manufacturing Sources
(DMS) Support
• Enhanced Product-Change Notification
• Qualification Pedigree (1)
• 2-A Low-Dropout (LDO) Voltage Regulator
• Open-Drain Power-On Reset With 100-ms
Delay
• Ultralow 75-μA Typ Quiescent Current
• Fast Transient Response
• 2% Tolerance Over Specified Conditions for
Fixed-Output Versions
• 20-Pin TSSOP (PWP) PowerPAD™ Package
• Thermal Shutdown Protection

DESCRIPTION
The TPS75201M-EP is a low dropout regulator with an integrated power-on reset (RESET) function. This device
is capable of supplying 2 A of output current with a dropout of 210 mV. Quiescent current is 75 μA at full load
and drops down to 1 μA when the device is disabled. The TPS75201M-EP is designed to have fast transient
response for larger load current changes.
Because the PMOS device operates like a low-value resistor, the dropout voltage is very low (typically 210 mV at
an output current of 2 A) and is directly proportional to the output current. Additionally, since the PMOS pass
element is a voltage-driven device, the quiescent current is very low and independent of output loading (75 μA
typ over the full range of output current, 1 mA to 2 A). These two key specifications yield a significant
improvement in operating life for battery-powered systems.
The device is enabled when the enable (EN) input is connected to a low-level input voltage. This low-dropout
(LDO) device also features a sleep mode; applying a TTL high signal to EN shuts down the regulator, reducing
the quiescent current to 1 μA at TJ = 25°C.
The RESET (SVS, POR, or power-on reset) output of the TPS75201M-EP initiates a reset in microcomputer and
microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS75201M-EP
monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage.
When the output reaches 95% of its regulated voltage, RESET goes to a high-impedance state after a 100-ms
delay. RESET goes to a logic-low state when the regulated output voltage is pulled below 95% (i.e., overload
condition) of its regulated voltage.
The TPS75201M-EP is adjustable (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is
specified as a maximum of 2% over line, load, and temperature ranges.