|
1.1 Features 1
• Low supply-voltage range: 3.6 V down to 1.8 V
• Ultra-low power consumption
– Active mode (AM) All system clocks active
– 195 μA/MHz at 8 MHz, 3 V, flash program execution (typical)
– 115 μA/MHz at 8 MHz, 3 V, RAM program execution (typical)
– Standby mode (LPM3)
– Real-time clock (RTC) with crystal, watchdog, and supply supervisor operational, full RAM retention, fast wakeup: 1.9 μA at 2.2 V, 2.1 μA at 3 V (typical)
– Low-power oscillator (VLO), general-purpose counter, watchdog, and supply supervisor operational, full RAM retention, fast wakeup: 1.4 μA at 3 V (typical)
– Off mode (LPM4) Full RAM retention, supply supervisor operational, fast wakeup: 1.1 μA at 3 V (typical)
– Shutdown mode (LPM4.5) 0.18 μA at 3 V (typical)
• Wake up from standby in less than 5 μs
• 16-bit RISC architecture, extended memory, up to 25-MHz system clock
• Flexible power-management system
– Fully integrated LDO with programmable regulated core supply voltage
– Supply voltage supervision, monitoring, and brownout
• Unified clock system
– FLL control loop for frequency stabilization
– Low-power low-frequency internal clock source (VLO)
– Low-frequency trimmed internal reference source (REFO)
– 32-kHz watch crystals (XT1)
– High-frequency crystals up to 32 MHz (XT2)
• 16-bit Timer TA0, Timer_A with five capture/compare registers
• 16-bit Timer TA1, Timer_A with three capture/compare registers
• 16-bit Timer TA2, Timer_A with three capture/compare registers
• 16-bit Timer TB0, Timer_B with seven capture/compare shadow registers
• Two universal serial communication interfaces (USCIs)
– USCI_A0 and USCI_A1 each support:
– Enhanced UART with automatic baud-rate detection
– IrDA encoder and decoder
– Synchronous SPI
– USCI_B0 and USCI_B1 each support:
– I2C
– Synchronous SPI
• Full-speed universal serial bus (USB)
– Integrated USB-PHY
– Integrated 3.3-V and 1.8-V USB power system
– Integrated USB-PLL
– Eight input and eight output endpoints
• 10-bit analog-to-digital converter (ADC) with window comparator
• Comparator
• Hardware multiplier supports 32-bit operations
• Serial onboard programming, no external programming voltage needed
• Three-channel internal DMA
• Basic timer with RTC feature
• Device Comparison summarizes the available family members
|