|
Minimum instruction execution time can be
changed from high speed (0.03125 s: @ 32 MHz
operation with high-speed on-chip oscillator) to
low-speed (1 s: @ 1 MHz operation with highspeed on-chip oscillator)
General-purpose registers: 8 bits 32 registers (8 bits 8 registers 4 banks)
ROM: 16 KB, RAM: 1.5 KB, Data flash: 2 KB
High-speed on-chip oscillator
Select from 32 MHz (TYP.), 24 MHz (TYP.), 16
MHz (TYP.), 12 MHz (TYP.), 8 MHz (TYP.), 6
MHz (TYP.), 4 MHz (TYP.), 3 MHz (TYP.), 2
MHz (TYP.), and 1 MHz (TYP.)
On-chip single-power supply flash memory (with
prohibition of block erase/writing function)
Self-programming
On-chip debug function
On-chip power-on-reset (POR) circuit and voltage
detector (LVD)
On-chip watchdog timer (operable with the
dedicated low-speed on-chip oscillator)
On-chip clock output/buzzer output controller
On-chip BCD adjustment
I/O ports: 26 or 28 (N-ch open drain: 2)
Timer
16-bit timer TAU: 4 channels
Watchdog timer: 1 channel
Serial interface
CSI: 1 channel
UART: 1 channel
I2C 1 channel (2 slave addresses)
|