DESCRIPTION
The STLVDS050 is differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve signaling rate as high as 400Mbps.
The EIA/TIA-644 standard compliant electrical interface provides a minimum differential output voltage magnitude of 247 mV into a 100 Ω load and receipt of 100 mV signals with up to 1 V of ground potential difference between a transmitter and receiver.
The intended application of this device an signaling technique is for point-to-point baseband data transmission over controlled impedance media of approximately 100 Ω characteristic impedance.
The transmission media may be printed-circuit board traces, backplanes, or cables. (Note: The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media, the noise coupling to the environment, and other application specific characteristics).

■ MEETS OR EXCEED THE REQUIREMENTS OF ANSI EIA/TIA-644-1995 STANDARD
■ SIGNALING RATES UP TO 400Mbit/s
■ BUS TERMINAL ESD EXCEEDS 6KV
■ OPERATES FROM A SINGLE 3.3V SUPPLY
■ LOW-VOLTAGE DIFFERENTIAL SIGNALING WITH TYPICAL OUTPUT VOLTAGE OF 350mV AND A 100Ω LOAD
■ PROPAGATION DELAY TIMES:
   DRIVER: 2ns (TYP)
   RECEIVER: 3ns (TYP)
■ POWER DISSIPATION AT 200MHz:
   DRIVER: 25mW (TYP)
   RECEIVER: 60mW (TYP)
■ LVTTL INPUT LEVELS ARE 5V TOLERANT
■ RECEIVER HAS OPEN-CIRUIT FAIL-SAFE