GENERAL DESCRIPTION
The Am29F010 is a 1 Mbit, 5.0 Volt-only Flash memory organized as 131,072 bytes. The Am29F010 is offered in 32-pin PLCC, TSOP, and PDIP packages. The bytewide data appears on DQ0-DQ7. The device is designed to be programmed in-system with the standard system 5.0 Volt VCC supply. A 12.0 volt VPP is not required for program or erase operations. The device can also be programmed or erased in standard EPROM programmers.

DISTINCTIVE CHARACTERISTICS
■ Single power supply operation
    — 5.0 V ± 10% for read, erase, and program operations
    — Simplifies system-level power requirements
■ High performance
    — 45 ns maximum access time
■ Low power consumption
    — 30 mA max active read current
    — 50 mA max program/erase current
    — <25 µA typical standby current
■ Flexible sector architecture
    — Eight uniform sectors
    — Any combination of sectors can be erased
    — Supports full chip erase
■ Sector protection
    — Hardware-based feature that disables/reenables program and erase operations in any combination of sectors
    — Sector protection/unprotection can be implemented using standard PROM programming equipment
■ Embedded Algorithms
    — Embedded Erase algorithm automatically pre-programs and erases the chip or any combination of designated sector
    — Embedded Program algorithm automatically programs and verifies data at specified address
■ Minimum 100,000 program/erase cycles guaranteed
■ Package options
    — 32-pin PLCC
    — 32-pin TSOP
    — 32-pin PDIP
■ Compatible with JEDEC standards
    — Pinout and software compatible with single-power-supply flash
    — Superior inadvertent write protection
■ Data# Polling and Toggle Bits
    — Provides a software method of detecting program or erase cycle completion