SILICON LABEL DESCRIPTION The DS2506 64 kbits Add-Only Memory identifies and stores relevant information about the product to which it is associated. This lot or product specific information can be accessed with minimal interface, for example a single port pin of a microcontroller. FEATURES ■ 65536 bits Electrically Programmable Read Only Memory (EPROM) communicates with the economy of one signal plus ground ■ Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number + 8-bit CRC tester) assures absolute traceability because no two parts are alike ■ Built-in multidrop controller ensures compatibility with other MicroLAN products ■ EPROM partitioned into two hundred fifty six 256-bit pages for randomly accessing packetized data records ■ Each memory page can be permanently writeprotected to prevent tampering ■ Device is an “add only” memory where additional data can be programmed into EPROM without disturbing existing data ■ Architecture allows software to patch data by superseding an old page in favor of a newly programmed page ■ Reduces control, address, data, power, and programming signals to a single data pin ■ Directly connects to a single port pin of a microprocessor and communicates at up to 16.3 kbits per second ■ Overdrive mode boosts communication speed to 142 kbits per second ■ 8-bit family code specifies DS2506 communications requirements to reader ■ Presence detector acknowledges when the reader first applies voltage ■ Low cost PR35 or 8-pin SOIC surface mount package ■ Reads over a wide voltage range of 2.8V to 6.0V from -40°C to +85°C; programs at 11.5V to 12.0V from -40°C to +50°C
|