CS6422-CSZ datasheet(31/48 Pages) CIRRUS

31 / 48 page

CS6422

Figure 8 shows the suggested placement of decou-

pling capacitors for the power supplies. Note that

the trace length from the power pin to the capaci-

tors is minimized. Also note that the smaller valued

capacitor is placed closer to the pin than the larger

valued capacitor. The smaller capacitor decouples

high frequency noise and the larger capacitor atten-

uates lower frequencies.

The separation of analog and digital power and

ground is done in two ways. The power is separated

by deriving the digital power for the CS6422 from

the analog through a ferrite bead to isolate analog

from digital, as shown in Figure 9. The ferrite bead

serves as a low-pass filter to remove CS6422 digi-

tal switching noise from the analog power supply.

The ground is separated by isolating all the digital

components of the system board on one ground

plane and all the analog and linear components on

a different ground plane. The CS6422 should be

placed over the analog ground plane. This prevents

digital switching noise from the digital components

of the board from coupling into the converters and

aliasing into the passband.

+5V

(Analog)

AVDD

AGND

DVDD

DGND

Analog Ground Plane

Digital Ground Plane

Microcontroller

µF0.1 µF0.1 µF10 µ F

Ferrite Bead

CS6422

Figure 9. Ground Planes

CS6422

DS295F1

CS6422-CSZ 数据表(PDF) 31 Page - Cirrus Logic

CS6422-CSZ 数据表(HTML) 31 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表下载

链接网址

CS6422-CSZ 数据表(PDF) 31 Page - Cirrus Logic

CS6422-CSZ 数据表(HTML) 31 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

数据表 下载

链接网址

数据表下载