ISM330DLC datasheet(38/116 Pages) STMICROELECTRONICS

部件名	ISM330DLC

功能描述	iNEMO inertial module: 3D accelerometer and 3D gyroscope with digital output for industrial applications

PDF	116 Pages

Scroll/Zoom	100%

制造商	STMICROELECTRONICS [STMicroelectronics]

网页	http://www.st.com

标志

38 / 116 page

Digital interfaces

ISM330DLC

38/116

DocID030686 Rev 2

Digital interfaces

6.1

I2C/SPI interface

The registers embedded inside the ISM330DLC may be accessed through both the I2C and

SPI serial interfaces. The latter may be SW configured to operate either in 3-wire or 4-wire

interface mode.

The serial interfaces are mapped onto the same pins. To select/exploit the I2C interface, the

CS line must be tied high (i.e connected to Vdd_IO).

6.2

Master I2C

If the ISM330DLC is configured in Mode 2, a master I2C line is available. The master serial

interface is mapped in the following dedicated pins.

Table 10. Serial interface pin description

Pin name

Pin description

SPI enable

I2C/SPI mode selection

(1: SPI idle mode / I2C communication enabled;

0: SPI communication mode / I2C disabled)

SCL/SPC

I2C Serial Clock (SCL)

SPI Serial Port Clock (SPC)

SDA/SDI/SDO

I2C Serial Data (SDA)

SPI Serial Data Input (SDI)

3-wire Interface Serial Data Output (SDO)

SDO/SA0

SPI Serial Data Output (SDO)

I2C less significant bit of the device address

Table 11. Master I2C pin details

Pin name

Pin description

MSCL

I2C serial clock master

MSDA

I2C serial data master

MDRDY

I2C master external synchronization signal

ISM330DLC 数据表(PDF) 38 Page - STMicroelectronics

ISM330DLC 数据表(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载