IRU1237SC

3

Rev. 1.2

07/14/03

www.irf.com

Ripple Rejection

Ripple Rejection

Ripple Rejection

Temperature Stability

Long Term Stability

RMS Output Noise

PARAMETER

SYM

TEST CONDITION

MIN

TYP

MAX

UNITS

30

30

40

40

40

50

150

0.5

0.3

0.003

4

12

8

20

dB

dB

dB

8C

%Vo

%Vo

%Vo

mA

mA

Note 7

8C, 1000Hrs

Note 7, 10Hz<f<10KHz

Note 1: Low duty cycle pulse testing with Kelvin con-

nections is required in order to maintain accurate data.

Note 2: Dropout voltage is defined as the minimum dif-

voltage drops 1% below its nominal value.

Note 3: Transient response is defined with a step change

until the output voltage reaches its minimum value.

Note 4: Minimum load current is defined as the mini-

mum current required at the output in order for the out-

put voltage to maintain regulation.

Note 5: The regulator shall withstand 100,000 reverse

bias discharges of the maximum output capacitance,

with no degradation, when the input voltage is switched

to ground in 1

ms.

Note 6: Temperature stability is the change in output

from nominal over the operating temperature range.

Note 7: Guaranteed by design, but not tested in produc-

tion.

PIN#

PIN SYMBOL

PIN DESCRIPTION

These pins are connected to ground. It is also the tab of the device.

Output #1. Fixed regulator output (3.3V).

Positive unregulated supply input for the regulator. This pin must always be higher than

properly. Bypass to ground with low ESR and ESL capacitance.

Output #3. Fixed regulator output (8V).

Input voltage to supply the base current for the pass transistor for both regulators.

Output #2. Fixed regulator output (2.6V).

PIN DESCRIPTIONS

1,4

2

3

5

6

7