Regulatory compliance

SPBTLE-1S

20/27

DocID030445 Rev 3

This module is evaluated for stand-alone use only. Finished products incorporating multiple

transmitters must comply with colocation and RF exposure requirements in accordance

with IC multi-transmitter product procedures. Collocated transmitters operating in portable

RF Exposure conditions (e.g. < 20 cm from persons including but not limited to body worn

and hand held devices) may require separate approval.

6.2.1

Labeling instructions

When integrating the SPBTLE-1S into the final product, the OEM must ensure that the IC

labeling requirements are satisfied. A statement must be included on the exterior of the

final product which indicates that the product includes a certified module. The label should

state the following (or similar wording that conveys the same meaning):

Contains IC: 8976C-SPBTLE1S

OR

This product contains IC: 8976C-SPBTLE1S

The OEM must include the following statements on the exterior of the final product unless

the product is too small (e.g. less than 4 x 4 inches):

This device complies with RSS-210 of the IC Rules. Operation is subject to the following

two conditions:



this device may not cause harmful interference

and



this device must accept any interference received, including any interference that may

cause undesired operation

6.2.2

Product manual instructions

This section applies to OEM final products containing the SPBTLE-1S module, subject to

IC compliance. The final product manual must contain the following statement (or a similar

statement that conveys the same meaning):

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment. (RSS-210)

In the case where an OEM seeks Class B (residential) limits for the final product, the

following statement must be included in the final product manual:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to RSS-210 of the IC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:



Reorient or relocate the receiving antenna



Increase the separation between the equipment and receiver



Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected