© TT electronics plc

General Note

TT Electronics reserves the right to make changes in product specification without

notice or liability. All information is subject to TT Electronics’ own data and is

considered accurate at time of going to print.

OP290 Series

Issue D

07/2016

Page 4

OPTEK Technology, Inc.

1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200

www.optekinc.com | www.ttelectronics.com

Maximum Duty Cycle

OP290 (25 µs pulse width @ 5 A)

1.25%

(1)

Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]

260° C

(2)

Power Dissipation, Free Air

OP290, OP291, OP292, OP295, OP296, OP297

OP293, OP298

Power Dissipation, Board Mounted

OP290, OP291, OP292, op295, OP296, OP297

OP293, OP298

Power Dissipation, Full Heat Sink

OP290, OP291, OP292, OP295, OP296, OP297

OP293, OP298

333 mW

(3)

142 mW

(3)

533 mW

(4)

200 mW

(4)

1.11 W

(5)

400 mW

(5)

Power Dissipation

OP294, OP299

180 mW

Electrical Specifications

Notes:

1. For OP290, OP291, OP292, OP295, OP296 and OP297, refer to graph of Maximum Peak Pulse Current vs Pulse Width.

2. For all OPs in this series, RMA flux is recommended. Duration can be extended to 10 second maximum when soldering. A maximum of 20 grams

force may be applied to the leads when flow soldering.

3. For OP290, OP291, OP292, OP295, OP296 and OP297, measured in free-air. Derate linearly 3.33 mW/° C above 25° C.

4. For OP290, OP291and OP292, mounted on 1/16” (1.6 mm) thick PCBoard with each lead soldered through 80 mil square lands 0.250” (6.35 mm)

below flange of device. Derate linearly 5.33 mW/°C above 62.5°. For OP293 and OP298, mounted on 1/16” (1.60 mm) thick PCBoard with each

lead soldered through 80 mil square lands 0.250” (6.35 mm) below flange of device. Derate power dissipation linearly 2.00 mW/°C above 25° C

(normal use). For OP295, OP296 and OP297, mounted on 1/16” (1.6 mm) thick PCBoard with each lead soldered through 80 mil square lands

0.250” (6.35 mm) below flange of device. Derate linearly 5.33 mW/°C above

25° C.

5. Immersed in silicone fluid to simulate infinite heat sink. For OP290, OP291 and OP292, derate linearly 11.1 mW/°C above 95°C. For OP293 and

OP298, derate power dissipation linearly 2.50 mW/° C above 25° C. For OP295, OP296 and OP297, derate linearly 11.1 mW/° C above 25° C.