M95080-RMB6 datasheet(14/40 Pages) STMICROELECTRONICS

14 / 40 page

M95160, M95080

14/40

Read Status Register (RDSR)

The Read Status Register (RDSR) instruction al-

lows the Status Register to be read. The Status

Write or Write Status Register cycle is in progress.

When one of these cycles is in progress, it is rec-

ommended to check the Write In Progress (WIP)

bit before sending a new instruction to the device.

It is also possible to read the Status Register con-

tinuously, as shown in Figure 9..

The status and control bits of the Status Register

are as follows:

WIP bit. The Write In Progress (WIP) bit indicates

whether the memory is busy with a Write or Write

Status Register cycle. When set to 1, such a cycle

is in progress, when reset to 0 no such cycle is in

progress.

WEL bit. The Write Enable Latch (WEL) bit indi-

cates the status of the internal Write Enable Latch.

When set to 1 the internal Write Enable Latch is

set, when set to 0 the internal Write Enable Latch

is reset and no Write or Write Status Register in-

struction is accepted.

BP1, BP0 bits. The Block Protect (BP1, BP0) bits

are non-volatile. They define the size of the area to

be software protected against Write instructions.

These bits are written with the Write Status Regis-

ter (WRSR) instruction. When one or both of the

Block Protect (BP1, BP0) bits is set to 1, the rele-

vant memory area (as defined in Table 3.) be-

comes

protected

against

Write

(WRITE)

instructions. The Block Protect (BP1, BP0) bits

can be written provided that the Hardware Protect-

ed mode has not been set.

SRWD bit. The Status Register Write Disable

(SRWD) bit is operated in conjunction with the

Write Protect (W) signal. The Status Register

Write Disable (SRWD) bit and Write Protect (W)

signal allow the device to be put in the Hardware

Protected mode (when the Status Register Write

Disable (SRWD) bit is set to 1, and Write Protect

(W) is driven Low). In this mode, the non-volatile

bits of the Status Register (SRWD, BP1, BP0) be-

come read-only bits and the Write Status Register

(WRSR) instruction is no longer accepted for exe-

cution.

Figure 9. Read Status Register (RDSR) Sequence

3456789 10 11 12 13 14 15

Instruction

AI02031E

6543210

Status Register Out

High Impedance

MSB

6543210

Status Register Out

MSB

M95080-RMB6 数据表(PDF) 14 Page - STMicroelectronics

M95080-RMB6 数据表(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

数据表下载