LO R976

Glossary

1)

Brightness: Brightness groups are tested at a current pulse duration of 25 ms and a tolerance of

±11 %.

2)

Reverse Operation: Reverse Operation of 10 hours is permissible in total. Continuous reverse opera-

tion is not allowed.

3)

Wavelength: Wavelengths are tested at a current pulse duration of 25 ms and a tolerance of ±1 nm.

4)

Forward Voltage: Forward voltages are tested at a current pulse duration of 1 ms and a tolerance of

±0.1 V.

5)

Thermal Resistance: Rth max is based on statistic values (6σ).

6)

Thermal Resistance: RthJA results from mounting on PC board FR 4 (pad size ≥ 5 mm² per pad)

7)

Typical Values: Due to the special conditions of the manufacturing processes of LED, the typical data

or calculated correlations of technical parameters can only reflect statistical figures. These do not nec-

essarily correspond to the actual parameters of each single product, which could differ from the typical

data and calculated correlations or the typical characteristic line. If requested, e.g. because of technical

improvements, these typ. data will be changed without any further notice.

8)

Characteristic curve: In the range where the line of the graph is broken, you must expect higher differ-

ences between single LEDs within one packing unit.

9)

Tolerance of Measure: Unless otherwise noted in drawing, tolerances are specified with ±0.1 and

dimensions are specified in mm.

10)

Tape and Reel: All dimensions and tolerances are specified acc. IEC 60286-3 and specified in mm.