ADC08032 datasheet(13/24 Pages) NSC

13 / 24 page

Functional Description (Continued)

When the start bit has been shifted into the start location

of the MUX register, the input channel has been as-

signed and a conversion is about to begin. An interval of

⁄2 clock period (where nothing happens) is automatically

inserted to allow the selected MUX channel to settle.

The SARS line goes high at this time to signal that a con-

version is now in progress and the DI line is disabled (it

no longer accepts data).

The data out (DO) line now comes out of TRI-STATE

and provides a leading zero for this one clock period of

MUX settling time.

During the conversion the output of the SAR comparator

indicates whether the analog input is greater than (high)

or less than (low) a series of successive voltages gener-

ated internally from a ratioed capacitor array (first 5 bits)

and a resistor ladder (last 3 bits). After each comparison

the comparator’s output is shipped to the DO line on the

falling edge of CLK. This data is the result of the conver-

sion being shifted out (with the MSB first) and can be

read by the processor immediately.

After 8 clock periods the conversion is completed. The

SARS line returns low to indicate this 1⁄2 clock cycle later.

The stored data in the successive approximation register

is loaded into an internal shift register. If the programmer

prefers the data can be provided in an LSB first format

[this makes use of the shift enable (SE) control line]. On

the ADC08038 the SE line is brought out and if held high

the value of the LSB remains valid on the DO line. When

SE is forced low the data is clocked out LSB first. On de-

vices which do not include the SE control line, the data,

LSB first, is automatically shifted out the DO line after

the MSB first data stream. The DO line then goes low

and stays low until CS is returned high. The ADC08031

is an exception in that its data is only output in MSB first

format.

All internal registers are cleared when the CS line is high

and the t

SELECT requirement is met. See Data Input Tim-

ing under Timing Diagrams. If another conversion is de-

sired CS must make a high to low transition followed by

address information.

The DI and DO lines can be tied together and controlled

through a bidirectional processor I/O bit with one wire.

This is possible because the DI input is only “looked-at”

during the MUX addressing interval while the DO line is

still in a high impedance state.

8 Single-Ended

DS010555-48

8 Pseudo-Differential

DS010555-49

4 Differential

DS010555-50

Mixed Mode

DS010555-51

FIGURE 1. Analog Input Multiplexer Options for the ADC08038

ADC08032 数据表(PDF) 13 Page - National Semiconductor (TI)

ADC08032 数据表(HTML) 13 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

数据表下载