EV6002DN-00A – MONOLITHIC FLYBACK/FORWARD DC-DC CONVERTER EV BOARD

NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV6002DN-00A Rev. 1.0

www.MonolithicPower.com

5

7/20/2009

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2009 MPS. All Rights Reserved.

TM

QUICK START GUIDE

1. Connect the positive terminal of the load to VOUT pin, and the negative terminal of the load to

GND pin.

2. Preset power supply output to 36V to 75V and turn off the power supply.

3. Connect the positive terminal of the power supply output to VIN pin, and the negative terminal of

the power supply output to GND pin.

4. Turn power supply on and the board will automatically startup.

5. To use Enable function, apply a digital input to EN pin. Drive EN with 1.2V-2.7V to turn on the

regulator, and drive EN less than 0.7V to turn it off.