EV4034-S-00A

85VAC-265VAC/50Hz, 40V/130mA

Primary-Side-Controlled,

Offline, LED Driver Evaluation Board

EV4034-S-00A Rev.1.0

www.MonolithicPower.com

1

12/19/2012

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2012 MPS. All Rights Reserved.

The Future of Analog IC Technology

DESCRIPTION

The

EV4034-S-00A

Evaluation

Board

demonstrates the capabilities of the MP4034: a

primary-side-controlled, offline, LED lighting

controller that eliminates secondary feedback

components.

The EV4034-S-00A typically drives a 5W LED

85VAC to 265VAC at 50Hz.

The EV4034-S-00A has excellent efficiency and

meets IEC61547 surge immunity and EN55015-

conducted EMI requirements. It has multiple

protections, including open-circuit protection,

short-circuit protection, a cycle-by-cycle current

limit, and over-temperature protection.

ELECTRICAL SPECIFICATION

Parameter

Symbol

Value

Units

Input Voltage

85 to 265

VAC

Output Voltage

40

V

LED Current

130

mA

Output Power

5.2

W

Efficiency (full load)

η

>80

%

FEATURES

 Primary-Side Control without Opto-Coupler

and Secondary Feedback Circuit

 Precise Constant Current (CC)

 Integrated 700V MOSFET with Minimal

External Components

 Variable, Off-Time, Peak-Current Control

 600µA High-Voltage Current Source

 Up to 5.2W Output Power

 Over-Voltage Protection (OVP)

 Over-Temperature Protection (OTP)

 Open-Loop Protection (OLP)

 Natural Frequency Dithering for Improved

EMI Signature

 Low Cost and Simple External Circuit

 Fits GU10 LED

APPLICATIONS

 Solid-State Lighting

 Industrial & Commercial Lighting

 Residential Lighting

All MPS parts are lead-free and adhere to the RoHS directive. For MPS

green status, please visit MPS website under Quality Assurance. “MPS” and

“The Future of Analog IC Technology”, are Registered Trademarks of

Monolithic Power Systems, Inc.

Warning:

Although this board is designed to satisfy safety

requirements, the engineering prototype has not been

agency approved. Therefore, all testing should be performed

using an isolation transformer to provide the AC input to the

prototype board.