TPIC1021 datasheet(3/13 Pages) TI

3 / 13 page

www.ti.com

Supply Voltage (VSUP)

Ground (GND)

Enable Input Pin (EN)

NWake Input Pin (NWake)

Inhibit Output Pin (INH)

TPIC1021

LIN Physical Interface

SLIS113 – OCTOBER 2004

RXD Wake-up Request

When the TPIC1021 has been in low power mode and encounters a wake-up event from the LIN bus or NWake

pin the RXD pin will go LOW while the device enters and remains in Standby Mode (until EN is re-asserted high

and the device enters Normal Mode).

The TPIC1021 device power supply pin. This pin is connected to the battery through an external reverse battery

blocking diode. The continuous DC operating voltage range for the TPIC1021 is from 7 V to +27 V. The VSUP is

protected to for harsh automotive conditions of up to + 40 V.

The device contains a reset circuit to avoid false bus messages during under-voltage conditions when VSUP is

less than VSUP_UNDER.

TPIC1021 device ground connection. The TPIC1021 can operate with a ground shift as long as the ground shift

does not reduce VSUP below the minimum operating voltage. If there is a loss of ground at the ECU level, the

TPIC1021 will not have a significant current consumption on the LIN pin while in the recessive state (<100 µA

sourced via the LIN pin) and for the dominant state the pull-up resistor should be active.

The enable input pin controls the operation mode of the TPIC1021 (Normal or Low Power Mode). When enable

is high, the TPIC1021 is in normal mode allowing a transmission path from TXD to LIN and from LIN to RXD.

When the enable input is low, the device is put into low power (sleep) mode and there are no transmission paths.

The device can enter normal operating mode only after being woken up. The enable pin has an internal

pull-down resistor to ensure the device remains in low power mode even if the enable pin floats.

The NWake input pin is a high-voltage input used to wake up the TPIC1021 from low power mode. NWake is

usually connected to an external switch in the application. A falling edge on NWake with a low that is asserted

longer than the filter time (tNWAKE) results in a local wake-up. The NWake pin provides an internal pull-up current

source to VSUP.

The inhibit output pin is used to control an external voltage regulator that has an inhibit input. When the

TPIC1021 is in normal operating mode, the inhibit high-side switch is enabled and the external voltage regulator

is activated. When TPIC1021 is in low power mode, the inhibit switch is turned off, which disables the voltage

regulator. A wake-up event on for the TPIC1021 will return the INH pin to VSUP level. The INH pin output current

is limited to 2 mA. The INH pin can also drive an external transistor connected to an MCU interrupt input.

TPIC1021 数据表(PDF) 3 Page - Texas Instruments

TPIC1021 数据表(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

数据表下载