 |
数据搜索系统，热门电子元器件搜索 |
|
|
数据搜索系统，热门电子元器件搜索 |
|
ADA4432-1BCPZ-R2 数据表(PDF) 3 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
ADA4432-1BCPZ-R2 数据表(HTML) 3 Page - Analog Devices |
|
|
3 / 25 page  Data Sheet ADA4432-1/ADA4433-1 Rev. E | Page 3 of 25 SPECIFICATIONS ADA4432-1 SPECIFICATIONS TA = 25°C, +VS = 3.3 V, RL = 150 Ω, unless otherwise specified. Table 1. Parameter Test Conditions/Comments Min Typ Max Unit DYNAMIC PERFORMANCE −3 dB Small Signal Bandwidth VOUT = 0.2 V p-p 10.5 MHz −3 dB Large Signal Bandwidth VOUT = 2 V p-p 9.3 10.5 MHz ADA4432-1W only: TMIN to TMAX 8.6 MHz 1 dB Flatness VOUT = 2 V p-p 8.3 9.4 MHz ADA4432-1W only: TMIN to TMAX 7.6 MHz 0.1 dB Flatness VOUT = 2 V p-p 3.3 MHz Out-of-Band Rejection f = 27 MHz, VOUT = 2 V p-p 37 43 dB ADA4432-1W only: TMIN to TMAX 35 dB Differential Gain Modulated 10-step ramp, sync tip at 0 V 0.38 % Differential Phase Modulated 10-step ramp, sync tip at 0 V 0.69 Degrees Group Delay Variation f = 100 kHz to 5 MHz 8 ns Pass Band Gain 5.80 6 6.24 dB ADA4432-1W only: TMIN to TMAX 5.57 6.44 dB NOISE/HARMONIC PERFORMANCE Signal-to-Noise Ratio 100% white signal, f = 100 kHz to 5 MHz 70 dB INPUT CHARACTERISTICS Input Voltage Range Limited by the output voltage range 0 to 1.34 0 to 1.4 0 to 1.45 V ADA4432-1W only: TMIN to TMAX 0 to 1.3 0 to 1.47 V Input Resistance >1.0 GΩ Input Capacitance 8 pF Input Bias Current 35 pA OUTPUT CHARACTERISTICS Output Offset Voltage VIN = 0 V 192 280 mV ADA4432-1W only: TMIN to TMAX 300 mV Output Voltage Swing RL = 150 Ω 0.28 +VS − 0.42 V ADA4432-1W only: TMIN to TMAX 0.30 +VS − 0.45 V Linear Output Current ±37 mA Short-Circuit Output Current ±50 mA SHORT-TO-BATTERY Overvoltage Protection Range +VS 18 V ADA4432-1W only: TMIN to TMAX +VS 18 V STB Output Trigger Threshold Back termination = 75 Ω 6.3 7.2 8.1 V ADA4432-1W only: TMIN to TMAX 6.0 8.4 V Disconnect Time After the fault is applied 150 ns Reconnect Time After the fault is removed 300 ns POWER SUPPLY Power Supply Range1 2.6 3.6 V Quiescent Current No input signal, no load 7.6 10 mA ADA4432-1W only: TMIN to TMAX 13 mA Quiescent Current, Disabled ENA = 0 V 14 20 µA ADA4432-1W only: TMIN to TMAX 25 µA Quiescent Current, Short-to-Battery Short-to-battery fault condition: 18 V 4.6 mA Quiescent Current, Short to Ground Short on far end of output termination (75 Ω) 47 mA PSRR Δ+VS RIPPLE = ±0.3 V, f = dc −63 dB ENABLE PIN Input Leakage Current ENA = high/low +0.3/−14 µA |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Chinese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
