LM4041G-AD-AE3-R datasheet(7/7 Pages) UTC

7 / 7 page

LM4041

LINEAR INTEGRATED CIRCUIT

UNISONIC TECHNOLOGIES CO., LTD

7 of 7

www.unisonic.com.tw

QW-R101-027.E



APPLI CAT I ON I N FORM AT I ON

VZ is set according to the equation shown as below which can be set by a user-defined resistor divider.

Cathode and Load Currents

The total current available to supply the load (IL) and bias the UTC LM4041 (IZ) is set by RS, so its value must be

set properly. In all cases, IZ must stay in a specified range for proper operation of the reference; RS must be small

enough to supply the minimum IZ. At maximum VS and minimum IL, to limit IZ to not exceed rating of 12 mA, RS must

be large enough.

RS=

)





UTC assumes no responsibility for equipment failures that result from using products at values that

exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or

other parameters) listed in products specifications of any and all UTC products described or contained

herein. UTC products are not designed for use in life support appliances, devices or systems where

malfunction of these products can be reasonably expected to result in personal injury. Reproduction in

whole or in part is prohibited without the prior written consent of the copyright owner. The information

presented in this document does not form part of any quotation or contract, is believed to be accurate

and reliable and may be changed without notice.

LM4041G-AD-AE3-R 数据表(PDF) 7 Page - Unisonic Technologies