11

MMK

■ Cased Relays with Plug-in Terminal

Cases on Models for Switching DC Loads

As shown at the right, there are three holes

with a 10-mm diameter in the case.

Terminal Arrangement/

Internal Connections

(Bottom View)

Note: Connect the common (C) to positive (+).

Make sure that all common connections are the

same in polarity. The markings of the common

connections on the casing all show "+" but the

polarity of the common connections can be ei-

ther all negative or all positive.

Standard Relays

MM2KP

DC-switching Relays

MM2XKP

MM2(X)KP

MM2KP

80.5 max.

22

54.5 max.

(see note)

119 max.

64.5

max.

3.5

7

5

Note: It is recommended that 55 mm min. is allowed

for this side because the MM2XKP has a

curved protective plate on the side.

Terminal Arrangement/

Internal Connections

(Bottom View)

Note: Connect the common (C) to positive (+).

Make sure that all common connections are the same in polarity. The markings of the common connections on the casing all

show "+" but the polarity of the common connections can be either all negative or all positive.

Standard Relays

MM3KP

DC-switching Relays

MM3XKP

MM3(X)KP

MM4(X)KP

80.5 max.

72.5 max.

(see note)

123 max.

7

22

3.5

64.5

max.

MM4KP

MM4KP

MM4XKP

Note: It is recommended that 73 mm min.

is allowed for this side because the

MM3XKP and MM4XKP have a

curved protective plate on the side.

Case Protective Plate

Be sure the polarity is

correct when connecting

Exposed Models.

This example is for the MN2XK.

This also applies to models with 3 or 4 poles.