24

Electromagnetic Coupling RFID System

V600

V600-HS61

• Facing: 80 mm min.

• Side-by-side: 80 mm min.

V600-HS61

V600-HS61

Note: If the two R/W Heads are not transmitting simultaneously (i.e., independent read/write), mutual interference will not occur. Therefore, the

restriction on the distance between the Heads will not be applicable.

The commands will be received by the R/W Heads and transmission will oscillate between them.

Mutual Interference between Proximity Sensors

The V600-series Units use electromagnetic coupling (frequency: 530 kHz). When a V600 Unit is wired close to R/W Heads, Proximity Switches,

and Sensors that have an oscillating frequency between 400 and 600 kHz, the Proximity Sensor may malfunction, so be sure to install the Units

according to the distance restrictions specified in the following diagrams. Make sure to thoroughly test that the mounting positions and the fixed

positions of the Sensors are correct before putting them into actual operation.

V600-H07

• Vertical/Parallel: 400 mm min.

• Facing: 300 mm min.

120 mm min.

80 mm min.

80 mm min.

V600-HS51

V600-HS51

V600-H51

• Facing: 120 mm min.

V600-H52

• Facing: 80 mm min.

• Side-by-side: 80 mm min.

V600-HS51

• Facing: 80 mm min.

• Side-by-side: 80 mm min.

100 mm min.

80 mm min.

80 mm min.

V600-HS51

V600-HS51

• Side-by-side: 100 mm min.

V600-H51

V600-H51

V600-H52

V600-H52

V600-H51

V600-H51

V600-H52

V600-H52

80 mm min.

V600

-HS61

V600

-HS61

80 mm min.

400 mm min.

400 mm min.

Proximity Sensor

Proximity Sensor

V600-H07

300 mm min.

Proximity Sensor

V600-H07

Q124-E1-03.fm Page 24 Tuesday, May 30, 2006 5:22 PM