| 数据搜索系统,热门电子元器件搜索 |
|
UB264AL-AC-P08-R 数据表(PDF) 6 Page - Unisonic Technologies |
|
|
|||||||||||||||||||||||||||||
UB264AL-AC-P08-R 数据表(HTML) 6 Page - Unisonic Technologies |
|
6 / 11 page ![]() UB264A Preliminary CMOS IC UNISONICTECHNOLOGIESCO.,LTD 6 of 11 www.unisonic.com.tw QW-R502-832.b OPERATING 1. Overcharge Detection Under normal conditions, when the voltage of any one cell battery exceeds the overcharge detection voltage (VCU) during charging, and after the state is retained for the overcharge detection delay time (tCU), CO will become “H”. This state is called overcharge. Attaching FET to the CO pin provides charge control and a second protection. Only the voltages of all the batteries decreases below the total of the overcharge detection voltage (VCU) and the overcharge hysteresis voltage (VHC), and the state is retained for the overcharge release delay time (tCL) or longer, CO will become “L”. 2. Overcharge Timer Reset When an overcharge release noise that forces the voltage of the battery temporarily below the overcharge detection voltage (VCU) is input during the overcharge detection delay time (tCU) from when VCU is exceeded to when charging is stopped, tCU is continuously counted if the time the overcharge release noise persists is shorter than the overcharge timer reset delay time (tTR). Under the same conditions, if the time the overcharge release noise persists is tTR or longer, counting of tCU is reset once. After that, when VCU has been exceeded, counting tCU resumes. 3. CTL Pin The CTL pin is used to control the output voltage of the CO pin. In the UTC UB264A Series, the CTL pin takes precedence over the overcharge detection circuit. CTL PIN CO PIN “H” Normal state (Note 1) Open “H” “L” “H” “L”→ “H” - “H” →“L” - Note: 1. The state is controlled by the overcharge detection circuit. Notes: 1. The reverse voltage “H” to “L” or “L” to “H” of CTL pin is VDD pin voltage −2.8V (Typ.), does not have the hysteresis. 2. Since the CTL pin implements high resistance of 8MΩ to 12MΩ for pull down, be careful of external noise application. If an external noise is applied, CO may become “H”. Perform thorough evaluation using the actual application. |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |