052218

115

F97-HT3 Series

High Temperature 135°C, Resin-molded Chip, High Reliability

TEST

F97-HT3 series (Temperature range -55°C to +135°C)

Condition

At 85°C, 85% RH For 1000 hours (No voltage applied)

Capacitance Change....Refer to page 114 (*1)

Dissipation Factor .... Initial specied value or less

Leakage Current .... 125% or less than the initial specified value

After 1000 hours application of rated voltage in series with a 33Ω resistor at 85°C, 85% RH capacitors

meet the characteristics requirements table below.

Capacitance Change ...Refer to page 114 (*1)

Dissipation Factor ........120% or less than the Initial specified value

Leakage Current...........200% or less than the initial specified value

At -55°C / +135°C,For 30 minutes each,1000 cycles

Capacitance Change ...Refer to page 114 (*1)

Dissipation Factor ........Initial specified value or less

Leakage Current...........Initial specified value or less

10 seconds reow at 260°C, 5 seconds immersion at 260°C.

Capacitance Change ...Refer to page 114 (*1)

Dissipation Factor ........Initial specified value or less

Leakage Current...........Initial specified value or less

After immersing capacitors completely into a solder pot at 245°C for 2 to 3 seconds, more than 3/4 of their electrode

area shall remain covered with new solder.

After application of surge in series with a 33Ω resistor at the rate of 30 seconds ON, 30 seconds OFF,for 1000

successive test cycles at 95°C,capacitors shall meet the characteristic requirements table below.

Capacitance Change ...Refer to page 114 (*1)

Dissipation Factor ........Initial specified value or less

Leakage Current...........Initial specified value or less

After 2000 hours application of rated voltage in series with a 3Ω resistor at 95°C,or derated voltage in series with a

3Ω resistor at 135°C,capacitors shall meet the characteristic requirements table below.

Capacitance Change ...Refer to page 114 (*1)

Dissipation Factor ........Initial specified value or less

Leakage Current...........Initial specified value or less

After applying the pressure load of 17.7N for 60 seconds horizontally to the center of capacitor side

body which has no electrode and has been soldered beforehand on a substrate, there shall be found

neither exfoliation nor its sign at the terminal electrode.

Keeping a capacitor surface-mounted on a substrate upside down and supporting the substrate at

both of the opposite bottom points 45mm apart from the center of capacitor, the pressure strength

is applied with a specified jig at the center of the substrate so that substrate may bend by 1mm as

illustrated. Then, there shall be found no remarkable abnormality on the capacitor terminals.

QUALIFICATION TABLE

Damp Heat

(Steady State)

Load Humidity

Temperature

Cycles

Resistance to

Soldering Heat

Solderability

Surge*

Endurance*

Shear Test

Terminal

Strength

* As for the surge voltage and derated voltage at 135°C, refer to page precautions for details.