FP7152 datasheet(11/14 Pages) FEELING

11 / 14 page

FP7152

This datasheet contains new product information. Feeling Technology reserves the rights to modify the product specification without notice.

No liability is assumed as a result of the use of this product. No rights under any patent accompany the sales of the product.

Website: http://www.feeling-tech.com.tw

Rev. 0.64

11/14

inductance value is recommended at higher supply voltages in order to minimize errors due to

switching delays, which result in increased ripple and lower efficiency. Higher values of inductance also

result in a smaller change in output current over the supply voltage range. The inductor should be

mounted as close to the device as possible with low resistance connections to the LX and VIN pins.

The chosen coil should have a saturation current higher than the peak output current and a continuous

current rating above the required mean output current.

DC Dimming

IOUTDC= 0.08*VADJ/RS (for 0.3< VADJ <2.5V). The ADJ pin can be driven by an external DC

voltage (VADJ) to adjust the output current to a value below the nominal average value defined by RS.

The LED current decreases linearly with the VADJ when 0.3V ≤ VADJ ≤ 2.5V, RS must be increased in

proportion to prevent IOUTDC exceeding 700mA maximum. When the VADJ falls below the threshold, 0.2V,

the output switch is turned off which allows PWM dimming.

FP7152

ADJ

GND

PWM Dimming

A Pulse Width Modulated (PWM) signal with duty cycle DPWM can be applied to the ADJ pin,

The PWM signal is recommended above 50kHz.As shown below, to adjust the output current to a value

above or below the nominal average value set by resistor RS:

FP7152

ADJ

GND

PWM

FP7152 数据表(PDF) 11 Page - Feeling Technology Corp.