Rev. G 08/16

13

TOP221-227

www.power.com

V

C(SHUNT)

I

CD1

I

CD2

36

5.5

5.7

6.0

±50

0.6

1.2

1.6

0.7

1.4

1.8

0.5

0.8

1.1

DRAIN Supply Voltage

Shunt Regulator

Voltage

Shunt Regulator

Temperature Drift

CONTROL Supply/

Discharge Current

V

V

ppm/

°C

mA

OUTPUT (cont.)

NOTES:

A. For specifications with negative values, a negative temperature coefficient corresponds to an increase in

magnitude with increasing temperature, and a positive temperature coefficient corresponds to a decrease in

magnitude with increasing temperature.

B. The breakdown voltage and leakage current measurements can be accomplished as shown in Figure 15 by

using the following sequence:

i. The curve tracer should initially be set at 0 V. The base output should be adjusted through a voltage

sequence of 0 V, 6.5 V, 4.3 V, and 6.5 V, as shown. The base current from the curve tracer should not

exceed 100 mA. This CONTROL pin sequence interrupts the Auto-restart sequence and locks the

TOPSwitch internal MOSFET in th OFF-state.

ii. The breakdown and the leakage measurements can now be taken with the curve tracer. The maximum

voltage from the curve tracer must be limited to 700 V under all conditions.

C. It is possible to start up and operate TOPSwitch at DRAIN voltages well below 36 V. However, the CONTROL

pin charging current is reduced, which affects start-up time, auto-restart frequency, and auto-restart duty cycle.

Refer to the characteristic graph on CONTROL pin charge current (I

tion characteristics.

Conditions

(Unless Otherwise Specified)

See Figure 14

SOURCE = 0 V

Min

Typ

Max

Parameter

Symbol

Units

See Note C

I

Output

TOP221-224

MOSFET Enabled

TOP225-227

Output MOSFET Disabled