DZM5168M

Revision 1.02

Page

of 17

Aug. 2014

15

24.

ATSL

ATSL is used to read or set the low 32-bit address of IEEE 64-bit address. Please refer to

ATSH for detailed use.

25.

ATSM

This command is only available for EndDevice. It is used to read or set the sleep mode of

EndDevice. The parameter value 1 enables the sleep function. When the EndDevice joins the

network, it keeps searching the network so it will not enter into sleep mode till it joins in a

network. EndDevice only can enter into sleep mode when all of the three conditions below

are met.

●

EndDevice has joined the network

●

Sleep mode is enabled

●

The sleep control pin 9 is logic high

26.

ATSP

nodes (Coordinator or Router). It is also the time for the EndDevice to read data from its

father nodes periodically. If the EndDevice is not able to read data from the father nodes in

this period, the data kept in Coordinator or Router will be cleared away. Therefore this

parameter of EndDevice must be the same as Coordinator or Router.

27.

ATST

28.

ATVR

This command is used to read the software version of module.

29.

ATWR

It’s a write command which is used to save the parameters changed by other commands into

nonvolatile memory and make the new parameters available when module is powered on

again.

When the module is powered on, it will read the parameters from the nonvolatile memory.

For the changed parameters, if they are not written into memory, the new parameters will get

lost when the module restarts next time. Please note even though some parameters are saved

into the memory, they only can come into effect at restart next time when some conditions

are met. For example the parameter of commands ATID only comes into effect after

restarting of the module after the commands ATRN and ATWR.