Security E

THAN0163_Rev.2.00_E

THine Electronics, Inc.

3/6

Copyright(C)2015 THine Electronics, Inc.

■Dip-Switch Setting

Dip-Switch can set the device address and the control signal input mode.

#2_TEST always set to Low.

1) Setting of the device address.

Device address can set the A0 to A5. Switch is the Low level when the ON side.

2) Setting of the control signal input mode.

Please refer to the following control signal input mode settings.

Table 1 Control signal input mode

Input Mode

MODE pin

3 wire serial CMOS

High

2 wire serial LVDS

Low

Figure 5 Example for DIP-Switch

■Input Mode Setting

In the case of change the control signal input mode, The following processing is required.

1) To 2 wire serial LVDS input: Please implement the 100 ohm resister to R517 and R519.

(Factory default settings)

2) To 3 wire serial CMOS input: Please remove the 100 ohm resister from R517 and R519.

Figure 6 Processed terminal resister