www.cherryswitches.com

Page 1 of 2

Last update 2016-07-12; specifications subject to change without notice.

Linear Position Sensors

LIN Sensors

– Kit with magnet

Thin, programmable, non-contact magnetic position sensors

with dual outputs available

Description

The LIN Series sensors are non-contact linear position sensors with one or two independent outputs. The sensors operate through the

use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output

(ratiometric to the input voltage) corresponding to a linear displacement of the actuator magnet.

The included actuator magnet is specifically paired to the sensor and is required to assure proper operation. Other magnets may yield

less than optimal performance.

Features

Typical Applications



Easy setup and robust monitoring with M4 screws



Dual independent (redundant) outputs assure high reliability



Custom programming available for: range, slope, PWM output



No mechanical interface means no parts to wear out or jam



Comes with 20 AWG 305 mm

(12”) discrete wire leads or harness

with connector



RoHS Compliant



IP68*



Suitable for wide air gap applications



Compliant to industrial/automotive EMC/EMI/ESD directives



Hydraulic valves



Hydraulic controls



Electric drives



Pneumatic controls



Zero-contact encoder alternative



Gear selection / shifting position

Environmental Specifications

Operating Temperature

Ingress Protection

IP68*

*Contact ZF for details on testing conditions

Electrical Specifications

Input

Supply Voltage

Maximum Overvoltage

Reverse Battery Protection

5.0 VDC ± 10%

16 VDC

12 VDC

Output Signal

0.5

– 4.5 VDC (with nominal input)

Input Current

Single output

8 mA typ., 10 mA max.

Dual output

16 mA typ., 20 mA max.

Resolution

12 bit

Accuracy, overall

±2% Full scale

Output Linearity

±1%Full scale

Mechanical Specifications

Measuring Range

Up to 45 mm

Air Gap**

4.5 mm (0.18

”)

Maximum Magnet Misalignment

2 mm

(0.08”)

**Output is calibrated to meet spec within air gap shown; any variation will affect performance