Output Protection Circuitry

Protected against false pulse on power-up, short-circuit protected

Output Response Time

Opposed Mode: 1.3 ms ON; 900 µs OFF

All Other Modes: 700 µs ON/OFF

NOTE: 120 ms delay on power-up; outputs do not conduct during this time.

Indicators

One Yellow and one Green LED (see Figure 1)

Construction

Polarized Retro Models: Thermoplastic elastomer housing with glass lens

All Other Standard Models: Thermoplastic elastomer housing with

polycarbonate lens

Chemical-Resistant Models: Housing encased in PFA jacket; cable encased

in 3/16 in O.D. PFA tubing

Output Ratings

OFF-state leakage current:

NPN: 200 µA

PNP: 10 µA

ON-state saturation voltage:

NPN: 1.25 V at 50 mA

PNP: 1.45 V at 50 mA

Vibration and Mechanical Shock

All models meet MIL-STD-202F, Method 201A (Vibration: 10 Hz to 60 Hz

maximum, 0.06 inch (1.52 mm) double amplitude, 10G maximum

acceleration) requirements. Also meets IEC 60947-5-2 (Shock: 30G 11 ms

duration, half sine wave) requirements.

Connections

Standard Models: 2 m (6.5 ft) or 9 m (30 ft) attached PVC cable, or 150 mm

(6 in) pigtail with M8 or M12 threaded connection, depending on the model

ordered

Chemical-Resistant Models: 2 m (6.5 ft) cable encased in 3/16 in O.D. PFA

tubing

Environmental Rating

Standard Models: IEC IP67

Chemical-Resistant Models: IEC IP67 (NEMA6) and PW12 1200 psi

washdown per NEMA ICS5, Annex F-2002

Conditions

Operating Temperature: –20 °C to +55 °C (–4 °F to +131°F)

Storage Temperature: –30 °C to +75 °C (–22 °F to +167 °F)

95% at +50 °C maximum relative humidity (non-condensing)

Certifications

(Chemical-resistant models are

not UR/UL approved.)

Required Overcurrent Protection

WARNING: Electrical connections must be

made by qualified personnel in accordance with

local and national electrical codes and

regulations.

Overcurrent protection is required to be provided by end product

application per the supplied table.

Overcurrent protection may be provided with external fusing or via Current

Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to

www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Dimensions

3.5 mm

(0.14")

22 mm

(0.86")

23.1 mm

(0.91")

3.4 mm

(0.13")

5.1 mm

(0.20")

15.0 mm

(0.59")

4.7 mm

(0.19")

Polarized Retro

Models

M3 mounting

screws included

8.0 mm

(0.31")

12.4 mm

(0.49")

Ø 3 mm (0.12")

max. torque

0.9 Nm (8 in-lbf)

Emitter (opposed mode models)

Emitter (all other models)

Figure 1. Standard Models

4

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 119223 Rev. K