Specifications

Sensing Beam

Visible red, 660 nm or Visible green, 525 nm , depending on model

Supply Voltage

10 to 30 V dc (10% max. ripple) at less than 25 mA, exclusive of load

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Output Configuration

Bipolar: 1 current sourcing (PNP) and 1 current sinking (NPN)

Output Rating

100 mA per output with short circuit protection

OFF-state leakage current: < 10 μA sourcing; 200 μA sinking

ON-state saturation voltage:

NPN: 1.6 V at 100 mA

PNP: 2.0 V at 100 mA

Output Protection

Protected against output short-circuit and false pulse on power up

NOTE: Maximum 100 ms delay on power

up; outputs do not conduct during this time

Output Response Time

Standard models (with crosstalk avoidance circuitry): 500

microseconds

High-speed models: 200 microseconds

Repeatability

Standard models: 95 microseconds

High-speed models: 50 microseconds

Adjustments

12-turn Sensitivity potentiometer with relative position indicator;

LO/DO Selection switch; 0 or 40 ms off delay switch

NOTE: Use proper ESD techniques while

making adjustments under cover.

Indicators

Two LEDs: Green and Amber

Green ON steady: Power ON

Alignment Indicating Device—the faster the flash, the more light is

received)

Construction

Black ABS/polycarbonate alloy (UL94 V-0 rated) housing, clear

polycarbonate cover

Environmental Rating

IEC IP50, NEMA 1

Connections

2 m or 9 m (6.5 ft or 30 ft) attached cable, or 4-pin Pico-style quick-

disconnect fitting; cables for QD models are purchased separately

Operating Conditions

Operating Temperature: −10 °C to +55 °C (+14 °F to +131 °F)

Storage Temperature: −20 °C to +85 °C (−4 °F to +185 °F)

90% at +55 °C maximum relative humidity (non-condensing)

Required Overcurrent Protection

WARNING: Electrical connections must be

made by qualified personnel in accordance

with local and national electrical codes and

regulations.

Overcurrent protection is required to be provided by end product

application per the supplied table.

Overcurrent protection may be provided with external fusing or via

Current Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Certifications

D10—Discrete Output

P/N 118431 Rev. B

www.bannerengineering.com - Tel: +1-763-544-3164

3