Figure 1. R-GAGE Features

1. Power LED: Green (power ON)

2. Signal Strength LED: Red, flashes in proportion to signal

strength. Steady on at 4x excess gain. Only indicates signal

amplitude, not target distance.

3. Output LEDs: Yellow (output energized) / Red

(configuration)

Access the DIP switches behind the threaded cap on the sensor back

(not shown)

D

X

Y

A

B

Zone 1

Zone 2

Figure 2. R-GAGE Sensing Zone Distances

EU, KR Models

TW, US Models

X

Minimum Zone 1 Distance

3 m (9.8 ft)

3.5 m (11.5 ft)

Y

Maximum Zone 1 Distance

12 m (39.4 ft)

12 m (39.4 ft)

A

Minimum Zone 2 Distance

8 m (26.2 ft)

8 m (26.2 ft)

B

Maximum Zone 2 Distance

24 m (78.7 ft)

24 m (78.7 ft)

D

Dead Zone3

Sensor Configuration

The sensing zone distance, sensitivity, and output configuration can be selected via the DIP switches on the back of the

sensor. Use the included spanner to open the screw-off cover on the back of the sensor and access the DIP switches.

Important: Tighten the DIP switch cover a full quarter turn after contact to maintain the watertight

seal.

DIP Switch Functions

Switch

Function

1, 2, 3

Zone 1 and Zone 2 distance pairs

4, 5

Sensitivity

6

Dual NPN/PNP output functionality

7

Normally Open/Normally Closed output functionality

8

Response Speed

DIP switch 1 is on the left and DIP switch 8 is on the right.

3 Typical dead zone: 0.4 m (1.3 ft) for moving and 1.0 m (3.3 ft) for stationary targets, but varies with target reflectivity.

2

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 187234 Rev. C